***Only available in Canada***

With its striking aesthetics, the S42 gas fireplace provides captivating warmth and enhances the architectural elements of your home.

A Focal-Point
The S42 is a wider version of the S36 and can provide more heat if needed to respond judiciously to more spacious spaces. Thanks to its large glass surface, this model offers a magnificent vision of the flames. As the pan burner disperses gas, the flames seem to move in a “fluid” motion. The realistic log set accentuated with glowing embers magically provides the experience of a real wood fire without the hassle. The narrow depth (17 7/8″) simplifies installation for new construction or your renovation project.

Make it Your Own
As you look through the safety invimesh, you must embellish the back wall of your fireplace with optional decorative panels, wood logs and lava rocks. Chose black steel for a subtle look; black reflective glass which will “mirror” some of the flame back at you; rustic or Herringbone brick panels for a more traditional look. Optional finishing trim available in two sizes, ensures a flawless finish around the edge of your fireplace. Those who want more heat can also opt for the addition of a variable speed blower.

Fitted with a ceramic glass which provides better heat transfer, the S42 is also equipped with a multi-functional remote control which provides intermittent or permanent pilot option, flame height and speed of the optional blower adjustment.


Available in natural gas (FG00004) or propane (FG00040) versions.

GENERAL FEATURES

Gas inlet diameter 1/2″ npt
Electrical requirement 115V / 60Hz
Maximum altitude allowed Up to 4,500′ (1,370 m)
Ignition type Electronic
Efficiency standard CAN/CSA-P.4.1-15 50.43% (NG) | 50.74% (LP)
Pilot type CONTINUOUS / INTERMITTENT
Maximum input (natural gas) 28,500 BTU/h
Maximum input (liquid propane) 26,500 BTU/h
Minimum input (natural gas) 21,000 BTU/h
Minimum input (liquid propane) 22,000 BTU/h
Requires electricity No
Turn down capacity 23.32% (NG) / 16.98% (LP)
Type of valve PROFLAME II
Vent dimension 4″ x 6 5/8″
Thermostatic or manual mode Yes
Fuel type Propane or natural gas
High-efficiency certified appliance Exempt
Electronic igniter Yes
Type of chimney Direct vent
Approved for a mobile home installation Yes
Door type Single, glass with steel frame
Glass type Ceramic glass
Glass surface – dimensions (Width X Height) 38” X 30 7/8”
Overall dimension (Height) 40 1/4”
Overall dimension (Width) 43 1/2”
Overall dimension (Depth) 17 7/8”
USA standard (safety) ANSI Z21.88 / CSA 2.33
Canadian standard (safety) ANSI Z21.88 / CSA 2.33
Tested and listed as per applicable standards By an accredited laboratory (CAN/USA)
Warranty Limited lifetime
Minimum clearances to combustibles*
(Data expressed in inches. 1 inch = 25.4 mm)
Clearance – back wall 0″
Clearance – corner 0″
Clearance – side wall 0″
Clearance – top (measured from the platform on which the appliance is installed)** 72″
Clearance – combustible side mantle to unit 6″
Clearance – combustible top mantle to unit 56 1/4″
Clearance – combustible side wall to unit 6″
Clearance – from the top of the unit to the shelf 56 3/8″

* The information given on the certification label affixed to the appliance always overrides the information published in any other media (owner’s manual, catalogues, flyers, magazines and/or web sites).

** Some appliances have been tested with a low ceiling. Before setting up your unit, refer to the installation manual.